2025 Liquid Force Flyer Wakesurf Board

Finally, a Wakesurf board that has it all. Drive, Speed, and Control!

After a year of being out in the wild, the Flyer has solidified its place in our line as an ultra-versatile thruster shape. The Flyer can hang back on a wave or drive down the line right back to the pocket within a moment’s notice. Which is why everyone loves it, except for boat drivers…everyone takes longer sets now, haha!!

The added volume in the Flyer’s middle section and tail really gives the Flyer forward thrust and added glide speed. Being able to maintain that momentum on the surf wave is key, it’s what’s everyone is chasing.

With a board as versatile as the Flyer, you might not want to surf anything else…and we don’t blame you!

Product Features

• Hand Glassed Construction
• EPS Foam Core with Wood Stringer
• Square Tail Shape
• Performance EVA Surf Traction Pad
• Front & Rear Foot Arch Bars
• Tri Fin Setup
• (2) Dual Tabbed Carbon Honeycomb Side Fins
• (1) Dual Tabbed Center Surf Fin

Benefits

MORE VOLUME

Easier to Ride! Increased volume helps the board sit higher in the water, which equates to better glide speed on the wave.

MID-WIDE TAIL

Gives you that cruise-control feel while in the pocket, but ready to break free and start slashing the moment you’re ready to carve!

PERFORMANCE EVA PADS

Our EVA Traction received a full makeover for 2025! Updated with square grooving and a micro-dot textured finish, our new traction pads are even easier on your feet without sacrificing an ounce of performance.

PRODUCT TECH

Performance Glass

Double bias fiberglass woven together with carbon inserts running nose to tail. This creates a single layer of glass that is lightweight yet durable and matches the performance of the overall design.

EPS Core

Expanded Polystyrene (EPS) foam is also known as beaded foam and features a closed cell core. EPS is made using small expandable beads that in- Rate with heat, and then are placed into a mold, where they expand to fit the shape. The expanded beads trap air, which gives expanded polystyrene its lightweight properties.

3mm Surf Stringer

A 3mm surf stringer adds strength to the foam blank and just enough flex and recoil to increase the surfboard's maneuverability. The wood stringer has remained a vital part of surfboard construction over the past half-decade.

Solar Powered
Fun Factory

Liquid Force is proud to announce that as of November 2020, all of our wakeboards, wakesurf boards, and foil boards that are produced by our partner factory SWS, are 100% produced by solar energy! We are happy to be able to to say that our boards are now "Made by the Sun" and that we are leading the charge in the global effort for sustainability and reduced carbon footprint.